Pre-Set Armrests (Standard Sedeoergo) - Sunrise Medical QUICKIE Q700 M Sedeo Ergo Manuel D'utilisation

4.2 Pre-set armrests (standard SedeoErgo)

Pre-set armrest height
The following section outlines armrest height adjustment. In the case
of either fine or gross adjustment, it is a two-part process:
PART I: Adjust the armrest height using the rear pivot.
PART 2: Adjust arm pad angle using the front pivot.
PART 1 (Fig. 4.4)
Up to 145 mm of armrest height adjustment can be achieved using
the 5.0 mm fine height adjustment screw to fine tune the armrest's
height.
• Use the 5.0 mm Allen key that is stored on the inside of the left
hand arm rest.
• Turn the screw, (A), at the upper rear pivot and your armrest will
move up or down depending on the rotation direction, (1) + (2).
PART 2 (Fig. 4.5)
• When your armrest is at the desired height, use the same tool to
turn the screw, (B), below the lower front pivot of the armrest.
• This proces will set the arm pad angle to the required setting, (2) +
(3).
Pre-set the arm pad fore and aft: (Fig. 4.6)
• Loosen the 2 bolts at the bottom of the arm pad rail.
• Slide the arm pad along the channel nuts.
• At this point some inward and outward angle adjustment is also
possible.
• Move the front bolt from front hole to the slot hole, (A).
• Tighten the bolts securely when the angle is set.
• When the correct position is reached tighten the 2 bolts securely
with the 5.0 mm Allen Key, (Hex Wrench).
• Place the tool in its original space so it can be used for further
adjustments in the future.
WARNING!
All screws should be checked periodically for tightness. A loose arm
pad could slip down when pressed
Sedeo Ergo Rev.1.0
.
A
A
2
B
3
B
2
1
Fig. 4.4
Fig. 4.5
Fig. 4.6
9