User Interfaces; Standard Control Panel - Grundfos CRE Notice D'installation Et De Fonctionnement

6. User interfaces

WARNING
Hot surface
Death or serious personal injury
- Only touch the buttons on the display as the
product may be very hot.
You can make the pump settings by means of the following user
interfaces:
Control panels
•

Standard control panel.

See section 6.1 Standard control
• Advanced control panel.
See section 6.2 Advanced control
Remote controls
• Grundfos GO.
See section 6.3 Grundfos GO.
• Grundfos R100 remote control.
See section 6.4 R100 remote
If the power supply to the pump is switched off, the settings are
stored.
panel.
panel.
control.
6.1 Standard control panel
The pumps are fitted with this control panel as standard.
Fig. 30 Standard control panel
Pos. Symbol Description
Grundfos Eye
It shows the operating status of the pump.
1 For further information, see section
4.4 Changing the position of the control
panel.
2 - Light fields for indication of setpoint.
3 Up and down. They change the setpoint.
It allows radio communication with
Grundfos GO and other products of the
same type.
When you try to establish radio
communication between the pump and
4 Grundfos GO or another pump, the green
indicator light in Grundfos Eye on the
pump flashes continuously. Press
the pump control panel to allow radio
communication with Grundfos GO and
other products of the same type.
It makes the pump ready for operation or
starts and stops the pump.
Start
If you press the button when the pump is
stopped, the pump only starts if no other
functions with higher priority have been
5
enabled. See section
settings.
Stop
If you press the button when the pump is
running, the pump always stops. The
"Stop" text next to the button is on.
1
2
3
4
Stop
5
on
8. Description of
21