Changing The Position Of The Control Panel - Grundfos CRE Notice D'installation Et De Fonctionnement

8. Route the wires for the CIM module. See the example in fig.
19.
Fig. 19 Example of wire routing
9. Fit the CIM cover.
10. If the CIM module is supplied with an FCC label, then place
this on the terminal box. See fig. 20.
Fig. 20 FCC label
11. Fit the terminal box cover (fig. 14, B) and cross-tighten the
four mounting screws (fig. 14, A) to 6 Nm.
Make sure that the terminal box cover is aligned with
the control panel. See section
position of the control
16
FCC
4.4 Changing the
panel.

4.4 Changing the position of the control panel

DANGER
Electric shock
Death or serious personal injury
- Switch off the power supply to the motor and to the
signal relays. Wait at least 5 minutes before
starting any work on the motor. Make sure that the
power supply cannot be accidentally switched on.
You can turn the control panel 180 °. Follow the instructions
below.
1. Loosen the four screws (TX25) of the terminal box cover.
Fig. 21 Loosening the screws
2. Remove the terminal box cover.
Fig. 22 Removing the terminal box cover
3. Press and hold in the two locking tabs (A) while gently lifting
the plastic cover (B).
Fig. 23 Lifting the plastic cover