Avady Cristal LED Manuel D'instructions Et D'utilisation page 9

Instructions and user manual Device pH
3.3.3 Prepare the sensor for Start-up
1)Remove
protective cap of the
probe and keep it for
reuse at the time of
wintering.
3.3.4 Mountingof the clamp
This assembly isfixed on the pipe.
Votr
e
O-Ring
text
e ici
Fig. 5
3.3.5Mounting of injection valve
H
3.3.6 Mounting of the probe on the probe holder
After removing the protective cap from the electrode, you need to insert all the parts as shown in the fig.9.
When all parts are engaged, tighten the nut without blocking it then push slowly the electrode to the
bottom of the hose and lift it about 2 cm so that the electrode tip is at the middle of the hose. Connect the
probe to the back of the pump on the BNC. (fig.10)
the
A nut
Put Teflon tape on threads
Fig. 7
Pierce the top wall of the pipe through
the clamp :
Percer la paroie supérieur du tuyau à
Next
travers les colliers de prise en
charge 8mm pour le clapet d'injection
et 14mm de diamètre pour la sonde
G
7
NOT065ENV02
2) Rinse the probe in tap water for at
least 20 minutes, that is why we
suggest you to Devicet with this step.
- Ø 8mm for the injection valve
- Ø 14 mm for the probe.
Fig. 6
Put Teflon tape on threads
Fig. 8