Proper Use Of The Pump; Risks - Avady Cristal LED Manuel D'instructions Et D'utilisation

Instructions and user manual Device pH

1.3 - PROPER USE OF THE PUMP

The pump should be used only for the purpose for which it has been expressly designed namely the dosing
of liquids. Install the pump in a dry place and well away from sources of heat, and in any case, at
environmental temperature not exceeding 40°C. The operating minimum temperature depends of the
liquid to be pumped, bearing in mind that it must always remain in a liquid state. Any different use is to be
considered dangerous. The pump should not therefore be used for applications that were not allowed for
in its design. In case of doubt please contact our offices for further information about the characteristics of
the pump and it proper use. The manufactures can not be held responsible for damage deriving for
improper, erroneous or unreasonable use of the pump.
Please read carefully the followings:

This appliance can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision
or instruction concerning use of the appliance in a safe way and understand the hazards involved.

Children shall not play with the appliance.

Cleaning and user maintenance shall not be made by children without supervision.

1.4 - RISKS

After unpacking the pump, make sure that it is completely sound. In case of doubt, do not use the pump
and contact qualified personnel. The packing materials (plastic bags, polystyrene, etc.) should be kept out
of the reach of children: they constitute potential sources of danger.
Before you connect the pump make sure that the voltage ratings correspond to your particular voltage
supply. You will find this value on the rating plates attached to the pump.
The electrical installation to which the pump is connected must comply with the standards and good
practice rule in force in the country under consideration.
Use of electrical equipment always implies observance of some basic rules. In particular:
- Do not touch with wet or damp hands or feet.
- Do not operate the pump with bare feet (typical place: swimming pool )
- Do not leave the equipment exposed to the atmospheric agents
- Do not allow the pump to be used by children or unskilled individuals without supervision
• The device must be supplied through a circuit with a residual current differential device (RCD) rated
differential operating current not exceeding 30 mA
• The appliance must be placed in a place that can not be flooded.
• The appliance must be connected electrically via a means of disconnection to the supply network, the
opening of the contacts of all the poles ensuring a complete break under the conditions of overvoltage
category III.
• The mains protection of the device is achieved by a thermal fuse T315 mA 250V.
In case of breakdown or improper functioning of the pump, switch off, but do not touch. Contact our
technical assistance for any necessary repairs and insist on the use of original spares. Failure to respect this
condition could render the pump unsafe to use.
• For Australia and New Zeland Only, For stationary appliances permanently connected to the fixed wiring,
compliance with this requirement is considered to be met if the instruction considering disconnection
incorporated in the fixed wiring is in accordance with AS/NZS 3000.
2
NOT065ENV02