Warn 83405 Instructions De Montage page 7

INSTALLATION CONT.
9. Install mounting plate assembly on the ve-
hicle, as shown in Figure 9. Slide assembly
between frame tube and radiator shroud in
a horizontal position with winch up. Once
the assembly is past the radiator shroud,
rotate the winch down and rearward and rest
against the vehicle frame. Shift the winch
clutch handle to freespool by rotating clock-
wise, then pull out 12 inches of winch cable
between fairlead brackets. Reinstall vehicle
grille with pin clips removed previously.
10. Pull the winch cable through bumper and
position bumper for installation on vehicle,
as shown in Figure 10. Fairlead brackets
will extend through front of bumper when
bumper is properly positioned.
11. Reinstall the top bumper mount capscrews
which were removed in Step 1, as shown in
Figure 11. Do not tighten at this time.
PAGE 7
Figure 9
Figure 10
Figure 11
83406A0