Warn 83875 Instructions D'installation

Your safety, and the safety of others, is very important. To help you make informed decisions about safety,
we have provided installation and operating instructions and other information on labels and in this guide. This
information alerts you to potential hazards that could hurt you or others. It is not possible to warn you about all
potential hazards associated with this product, you must use your own good judgment.
CARELESS INSTALLATION AND OPERATION CAN RESULT IN SERIOUS INJURY OR EQUIPMENT DAM-
AGE. READ AND UNDERSTAND ALL SAFETY PRECAUTIONS AND OPERATING INSTRUCTIONS BE-
FORE INSTALLING AND OPERATING THIS PRODUCT.
This guide identifies potential hazards and has important safety messages that help you and others avoid personal
injury or death. WARNING and CAUTION are signal words that identify the level of hazard. These signal words
mean:
WARNING signals a hazard that could cause serious injury or death, if you do not follow
recommendations.
follow recommendations.
This guide uses NOTICE to call attention to important mechanical information, and Note: to emphasize general
information worthy of special attention.
Failure to observe these instructions could lead to severe injury or death.
Always Read the Plow Operator's Manual, the Winch Operator's Manual and all warning labels before operating.

 Always use extreme caution when drilling on any vehicle. Make sure that all fuel lines, brake lines, electrical
wires, and other objects are not punctured or damaged when/if drilling on the vehicle. Thoroughly inspect the
area to be drilled (on both sides of material) prior to drilling, and relocate any objects that may be damaged.
Failure to inspect the area to be drilled may result in vehicle damage, electrical shock, fire or personal injury.
Always wear safety glasses when installing this kit.

Always use extreme caution when cutting and trimming during fitting.

Always remove jewelry and wear eye protection.

Always use appropriate and adequate care in lifting components into place.

Always insure components will remain secure during installation and operation.

Always tighten all nuts and bolts securely, per the installation instructions.

Always operate the vehicle at a walking speed with the blade installed. Never exceed 5 mph (8 km/h), even with

blade up.
Always plow cautiously, impact with hidden or stationary object may cause the vehicle to stop suddenly or go out

of control.
Never operate the vehicle on slopes greater than 10 degrees with the plow installed.

 Never stand or ride on the plow.
Always stay clear of moving parts and joints. Always keep others away when operating or adjusting plow.

 Always perform regular inspections and maintenance on the plow mechanism, fasteners, cable and related
hardware.
Always replace all worn or damaged parts before operating.

Never operate this WARN product with damaged or missing parts.

Always drive slowly over bumpy and rough terrain. Driving at speeds that cause the plow to bounce while in the

up position can cause the winch to back-drive, causing the plow to work its way down. This may result in the plow
impacting a stationary object and cause damage to the vehicle and operator injury or death.
Always drive at speeds such that the plow does not bounce and be aware of the plow position while driving at all

times.
Never raise the top of the plow above the headlights of the ATV, as it may damage the vehicle and plow.

WARN® INDUSTRIES
INSTALLATION INSTRUCTIONS
Arctic Cat Prowler Plow Mounting Kit
Application:
CAUTION signals a hazard that may cause minor to moderate injury, if you do not
WARN Part Number: 83875
Arctic Cat Prowler 650 2006+
Arctic Cat Prowler 700 2008+
WARNING
INJURY HAZARD
PAGE 1 83874A0