Warn 83405 Instructions De Montage page 4

VI. INSTALLATION
1. Remove capscrews on side of bumper, as
shown in Figure 1, using a 14mm socket.
The top mounting hardware will be used for
reinstallation of the bumper.
2. Remove capscrews at bottom of bumper skid
plate using a 10mm socket, as shown in Fig-
ure 2. This hardware will be used for rein-
stallation of bumper. Remove bumper from
vehicle.
3. Using a screwdriver, remove and save the
two lower pin clips that retain the grill. Refer
to Figure 3.
PAGE 4
Remove Capscrews
Figure 1
Remove Capscrews
Figure 2
Remove Lower Pin Clips
Figure 3
83406A0