Emaintenance; Foperating Temperatures; Gtroubleshooting - Tectro TS 825 Manuel D'utilisation

Masquer les pouces Voir aussi pour TS 825:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
E
MAINTENANCE
Cleaning the front panel
1.
Turn off the device and pull the plug out of the socket.
2.
Grab the front panel at position "a" and pull it towards you.
3.
Clean with a soft, dry cloth.
Use lukewarm water (max. 30˚ C) to remove persistent dirt.
4.
Never use volatile substances like gasoline, or an abrasive to remove dirt.
5.
Never spray water on the indoor unit.
Danger! Electrical shock!
6.
Replace the front panel and close it by pressing down position "b".
Cleaning the air filter
The air filter must be cleaned regularly.
Do this as follows:
1.
Turn off the device completely.
- Open the front panel.
- Grab the lever and pull the filter out.
2.
Clean the air filter and insert it again.
Clean a very dirty filter in lukewarm water with detergent. Let the filter completely dry at a spot wit-
hout direct sunlight after cleaning.
3.
Close the front panel.
When the air conditioner is being used in a very dusty environment, it has to be cleaned every two
weeks.
F
OPERATING TEMPERATURES
Cooling, heating and / or dehumidifying is possible at the following inside or outside temperature.
Refrigeration
Room temperature
16 – 48°C
Outdoor temperature
0 – 48°C
4
50
Mode
Heating
Dehumidify
16 – 31°C
16 – 48°C
-15 – +24°C
0 – 48°C
G
TROUBLESHOOTING
Problem
Cause / Solution
The plug is not inserted correct in the socket.
The batteries of the remote control are empty.
Unit doesn't work.
The safety switch is activated or the fuse is blown.
Are the air inlets, outlets obstructed?
Is the temperature set correctly?
No cooled or heated air.
Is the air filter clogged?
Due to a malfunction (discharge of static electricity, power system failure) the
No effective control.
device will not work properly. If this is the case, pull the plug out of the soc-
ket and insert it again after 2-3 seconds.
Do not start the unit
Changing mode when the unit is in service: 3 minute delay.
immediately.
Odour might come form another source, furniture, cigarettes, etc. The unit
Unusual odour.
blows the sucked in air out again.
Cause by the refrigerant in the air conditioner, this is not a malfunction.
Sound of running water.
Sound of defrosting in the heating mode.
The sound can be caused by the expansion/contraction of the front panel due
Cracking sound.
to changes in temperature.
A lot of vapour/mist is
Vapour/mist is formed when the air temperature in the room drops strongly
coming out the air out-
because cold air is being exhausted in the COOLING or DRY mode.
let.
The red indicator light
for the compressor fla-
The unit switches from the heating mode to the defrost mode. The indication
shes continuous and the
light turns off within 10 minutes, the unit returns to the heating mode.
fan of the indoor unit is
not working anymore.
4
51

Hide quick links:

Publicité

Table des Matières
loading

Table des Matières