Cbefore Use; Operation - Tectro TS 825 Manuel D'utilisation

C
BEFORE USE
Before using the air conditioner you must check and set the following.
Setting remote control
The remote control is NOT set by the manufacturer for the function only cooling or heating, you have to
set these functions yourself.
Every time the batteries of the remote control are replaced, the arrow "Heat" or "Cool" on the display of
the remote control will flash.
Depending on your type of air conditioner, you must set the remote control as follows:
Press any button if the arrow in front of "Heat" flashes, the heat pump is set.
Press any button if the arrow in front of "Cool" flashes, only cooling is set.
If you don't press a button within 10 seconds, the remote control will automatically be set on cooling.
D

OPERATION

Operation and display
1. Indication LED Power on
Shows the air conditioner is turned on.
2. Indication LED sleep function
Shows the sleep function is activated.
3. Temperature indication LED
Shows the set temperature
4. Indication LED Timer function
Shows the timer function is activated.
5. Indication LED unit in service
Shows the unit is in service.
4
44
Remote control
The remote control sends signals to the system.
SLEEP BUTTON
To set or deactivate the SLEEP mode
TIMER BUTTON
To select the TIMER function.
MODE BUTTON
To select the operating mode:
Feel, Cooling, Dry, Fan and Heating
DOWN BUTTON (TOO HOT BUTTON)
To decrease the set room temperature
and reduce the time.
Note: Every mode and the relevant functions will be specified hereafter.
Placement of batteries
Remove the battery cover in the direction of the arrow.
Insert new batteries as shown (align the positive (+) and negative (-) symbols.
Slide the battery cover back in position.
Note: use 2 LR03 AAA(1.5volt) batteries. Do not use rechargeable batteries. Replace batteries with batteries
of the same type (see above) if the display becomes more blurred.
Storage of the remote control and tips for using
The remote control can be stored in a holder, mounted against the wall.
Using the remote control
Point the remote control towards the receiver on the indoor unit of the air conditioner. This way, the air
conditioner can be operated from a distance up to 7 meter.
UP BUTTON (TOO COLD BUTTON)
To increase the set room temperature
and lengthen the time.
FAN SPEED CONTROL BUTTON
To select the fan speed of the indoor unit:
automatic, high, medium and low.
CONTROL BUTTON (HORIZONTAL BLADE)
To set the direction of the air flow.
ON/OFF BUTTON
To turn on or off.
4
45