Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
IMS 100
3 3 . . 2 2 . . 2 2 . . I I n n s s t t a a l l l l a a t t i i o o n n o o f f s s u u r r f f a a c c e e m m o o u u n n t t e e d d s s e e n n s s o o r r
The sensor has to be installed on the elevator cab transom.
Step Action
1
Drill two 3.2 mm (1/8 inch) holes for the
sensor box (1) with 100 mm distance into
the elevator cab transom (2).
Drill a 10 mm (3/8 inch) hole into the ele-
vator cab transom (2) for the sensor ca-
ble.
For side-opening doors:
Keep a distance of 22 mm from the cor-
ner of the doorway.
2
Mount the sensor box (1) with the two
3.5 mm self-tapping screws (3) on the
elevator cab transom (2).
3
Snap the sensor (4) into the mounting
bracket (5).
4
Align the sensor to the lobby.
Angle: 0 ... 30°
4
Route cable up through the 10 mm hole
(3/8 inch) in the elevator cab transom.
Slide the sensor (4) with the mounting
bracket (5) into the hole and fix it with the
two mounting clips (6).
For removal of the clips please refer to
section 4.3
6
5
Angle: 0 ... 35°
Installation and Operation Manual
Illustration / note (all dimensions in mm)
2
1
2
1
4
Important note:
Observe for side opening doors.
The sensor must be mounted with the cable outlet facing the door
jamb.
www.cedes.com
6
© CEDES/April 2014
3
5
Publicité
Table des Matières
