Cedes IMS 100 Manuel D'installation Et D'utilisation page 7

Capteur qui est utilisé pour améliorer les systèmes de protection de porte d'ascenseur en fournissant la détection en face de l'entrée de la cabine d'ascenseur
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation and Operation Manual
3 3 . . 2 2 . . 3 3 . . I I n n s s t t a a l l l l a a t t i i o o n n o o f f f f l l u u s s h h m m o o u u n n t t e e d d s s e e n n s s o o r r
Step Action
1
Cut a square shape of 29 x 111 mm out
of the elevator cab transom (1).
Keep the distance to the edge (2) of the
elevator cab transom, hall side, as short
as possible.
→ The MINIMUM distance is 17 mm
→ The MAXIMUM distance is 250 mm
Drill two 4.7 mm (3/16 inch) diameter
holes for the mounting bracket (4) into
the elevator cab transom (1) with 120 mm
distance on the centerline (CL) of the
shape.
Keep the minimum distance of 7 mm
from the corner of the doorway.
2
Snap the sensor (3) into the mounting
bracket (5).
3
Align the sensor to the lobby.
Angle: 0 ... 30°
3
Route cable up through the hole in the
elevator cab transom. Slide the sensor
(3) with the mounting bracket (4) into the
hole and fix it with the two mounting clips
(5).
For removal of the clips please refer to
section 4.3
© CEDES/April 2014
4
Angle: 0 ... 35°
Illustration / note (all dimensions in mm)
1
CL
3
4
Important note:
Observe for side opening doors.
The sensor must be mounted with the cable outlet facing the door
jamb.
www.cedes.com
Hall Side
IMS 100
2
5
7

Publicité

Table des Matières
loading

Table des Matières