Roco RouteControl 10772 Mode D'emploi page 11

The following table lists all the variable Route-Control parameters:
parameter range of
values
C0 1-31
C1 4-256
C2 4-32
C3 0/1
C4 1-9
C5 0,1-9
C6 1-3
C7 0/1
C8 1-30
C9 1-30
CA 0/1
Cb ??
CC ??
Cd 0-119
Programming turnout decoders
Programming of the turnout drive 42624
red housing with both ROCO-Lokmaus
Systems:
1. Connect Lokmaus
Central unit/or amplifier;
2. Activate power supply;
3. Select the desired turnout address;
4. Press the emergency stop key of the Lokmaus
At Lokmaus 1 (10750) the red LED will blink,
®
at Lokmaus 2 (10760) and the RouteControl
®
the display will blink;
5. Connect green cable of the turnout drive with one
of the two rails (attach contact rail connector);
6. Press the emergency stop key of the Lokmaus
LED at Lokmaus 1
illuminated. The display of the Lokmaus 2
not blink any more;
defaul value description
3 DataBUS address
256 permissible number of turnouts (with „Maus-Bus" operation
only 128 at most!)
32 permissible number of track routes
1 set of turnouts erasable (1) or not (0)
2 time required for automatic completion of a numerical input
5 time required for call-up of the track route editor when
pressing the „esc" key. The value 0 deactivates the key for
this purpose (=child latch)
3 scroll mode: cursor keys are active only for turnouts when set
to (1), only track routes when set to (2), both turnouts and
track routes when set to (3). The numerical keyboard is not
influenced by this setting
0 when set to (1) will reset all menu settings and cancel all
track routes
2 response time in 100ms
8 dely time between two switching operations in 100ms
1 DataBUS automatic configuration: 1=on, 0=off
2.0 software version READ ONLY
3.0 DataBUS version READ ONLY
119 number of turnouts which can still be added to a track
route. This number will be computed automatically by the
RouteControl depending on the already programmed track
routes READ ONLY
and RouteControl to the
®
will again be continuously
®
®
7. Press "ok" key of the RouteControl;
8. Remove the green wire of the turnout drive
from the rail.
-
®
Programming of the turnout drive 42624 red
housing with the Lenz System:
1. Connect both LH 100 and the RouteControl to
the Central unit;
2. Activate power supply;
.
®
3. Select the desired turnout address with the
RouteControl;
4. Press the stop key and then "F" AND "0" of
the LH 100. The display of the RouteControl will
blink; at the LH 100 first "Stop" and "Aus* F0"
will appear alternating, then "Aus";
.
®
5. Connect green cable of the turnout drive with one
of the two rails (attach contact rail connector);
does
6. Again press the stop key of the LH 100. Displays
www.roco.cc
GB
11