Grammer COMPACTO Comfort S Mode D'emploi page 19

During the removal and installation of the driver's seat, the corresponding instructions by
• • • •
the specific vehicle manufacturer must be strictly observed!
Do not hold onto the covers for lifting the driver's seats. If you do so anyway, there is an
• • • •
increased risk of injury due to loosening or breaking covers.
Before you remove the driver's seat, disconnect all plug-in connections between the seat
• • • •
and the vehicle supply network. When you replace the plug-in connectors, make sure they
are tight (dust, water).
Seatbelts are fitted or can be retrofitted to the driver's seat. Seatbelts may only be fitted
• • • •
on the approval of the vehicle manufacturer, as they increase the load in the seat
mounting area.
Seatbelts must be fitted in accordance with specific national regulations and guidelines,
and must be approved by GRAMMER AG.
Seatbelts must be fastened before driving.
• • • •
The seatbelts must be replaced after an accident.
Where seatbelts are fitted to the driver's seat, the seat and seat mounting must be
checked additionally by specialist personnel after an accident has occurred.
Fasteners must be checked regularly for tight seat. If the seat wobbles, there may be
• • • •
loose bolts or other faults.
If you find that the seat does not function correctly (for example a defective suspension of
• • • •
the driver's seat; improper curvature of the lumbar support, etc.) or is damaged (e.g.
damaged bellows etc.) contact a specialist workshop immediately to arrange for repairs
to be carried out.
If you fail to do so, your health may be affected and the risk of accident increased.
Before the vehicle is used, switches that might be in the seat (for shutting down mechanical
• • • •
equipment when the driver leaves his/her seat) must be checked for proper function.
If malfunctions are detected, the vehicle must not be driven.
– INCREASED RISK OF ACCIDENT –
Loads must not be placed on seats with a built-in switch, except for the driver's weight
• • • •
during normal use, as the vehicle may otherwise start to move by itself.
– INCREASED RISK OF ACCIDENT –
If you take off the weight from the seat while driving, this will cause the vehicle to stop.
Do not indent the bellows while there is load on the driver's seat.
• • • •
– RISK OF CRUSHING –
Make sure that the interior of the driver's seat remains free of foreign particles or
• • • •
liquids.
The driver's seat is not watertight and must be protected against splashes of water!
• • • •
Any conversion or refitting work on a GRAMMER AG driver's seat must be performed
• • • •
exclusively in authorized workshops by trained or suitably qualified personnel and in
adherence with the applicable operating, maintenance and installation instructions and in
compliance with all relevant national regulations.
Improper installation and assembly bear the risk of bodily injury or property damage
• • • •
and the proper function of the driver's seat or mounted parts can no longer be guaranteed.
GB
Safety instructions
19