Orved A Mode D'emploi Et D'entretien page 60

GB
USING THE APPLIANCE
4) PROGRAMMING THE VAC+ FUNCTION (See page 50)
Select the :function; the relative LED starts flashing. Set the required value using arrows
proceed with the programming by pressing the required function key.
5) PROGRAMMING THE GAS FUNCTION (OPTIONAL) (See page 50)
Select the function; the relative LED starts flashing. Set the required value using arrows
proceed with the programming by pressing the required function key.
6) PROGRAMMING THE SEAL FUNCTION (See page 50)
Select the : function; the relative LED starts flashing. Set the required value using arrows
proceed with the programming by pressing the required function key.
7) PROGRAMMING THE SOFTAIR FUNCTION (OPTIONAL) (See page 50)
Select the :function; the relative LED starts flashing. Set the required value using arrows
is now possible to proceed with setting other programs or proceed with the packaging.
8) WORK CYCLE START : Lower the lid using both hands pressing it slighlty at the corners. The appliance will start the work cycle according to
the programmed parameters.
9) WORK CYCLE END: The appliance automatically ends the cycle after the sealing bar phase and re-entry of air in the chamber with consequent
opening of the lid. Remove the packed product and check the seal; it must be uniform, well marked and without melted points. Adjust the preset
values, if necessary, and proceed with the second cycle.
Activate the button; the work cycle can be interrupted at any moment; interruption is immediate with air re-entering the chamber. The work
cycle can also be interrupted by means of the ON/OFF main switch: when the appliance is switched off, the cycle is interrupted but air does not
return to the suction cup: the lid therefore remains closed.
When the appliance is switched on again, the cycle is reset, air returns to the chamber and the lid opens.
ACTIVATING AND DEACTIVATING THE GAS AND "SOFTAIR" FUNCTIONS mod. G - H - I - J - K - L - M - N - P - Q
ACTIVATION
- Press
- Press the function key to be activated; the display flashes alternately with "GAS/SI" or "SOF/SI"; a few seconds later, the value set is displayed.
Change the value using the cursor keys and/or confirm by means of
DEACTIVATION
- Press
- Press the key of the function to be deactivated, the display flashes showing "GAS/NO" or "SOF/NO"; a few seconds later the LED and function are deactivated.
1) Switch the appliance On and set the sealing value; deactivate the GAS and SOFTAIR present (programming a special cycle is recommended).
2) Press ; position the bag about 20mm beyond sealing bar (A), then start the cycle by lowering lid (B).
3) When vacuum formation has been completed inside the bag, press
when air returns to the chamber and the lid opens.
GB
ACTIVATING THE "PUMP" FUNCTION IN
MODELS WITH THREE-PHASE POWER
SUPPLY
The pump function can be activated both before and
after programming the appliance by pressing the
key; the relative LED lights up and the pump operation
noise becomes audible.
Operation and maintenance manual / Ed. 02 - 2006
INTERRUPTING THE WORK CYCLE mod. G - H - I - J - K - L - M - N - P - Q
PROGRAMMING THE JARS FUNCTION IN mod. H
FOR CREATING VACUUM IN EXTERNAL CHANNELLED BAGS
; the LED remains On and the function is activated.
. The appliance will proceed to the bag sealing phase. The cycle ends
CHANNELLED
BAG
•
•
A
60
VACUUM CHAMBER
PACKAGING MACHINES
and confirm by pressing , or
and confirm by pressing , or
and confirm by pressing , or
and confirm by pressing . It
•
B
REV. 00 - Cod.: 1500159