Orved A Mode D'emploi Et D'entretien page 56

GB
USING THE APPLIANCE
CREATING VACUUM IN EXTERNAL CONTAINERS AND BAGS ("JARS" FUNCTION) (mod. D - F)
CREATING VACUUM IN EXTERNAL CONTAINERS
1) Screw hose connector (A) supplied with the machine on the connection provided on the front and insert hose (B) provided with suction cup.
2) Prepare the lid fitted with a valve by slightly unscrewing ring nut (C) on the valve so that the sealing plug inside it can move.
3) Position suction cup (D) on the lid valve after placing it on the container (jar, vessel, vacuum box, etc.) inside which vacuum is to be
created.
4) Switch the machine On, turn the VAC control knob to "OFF" and all other control knobs to zero. When machine lid (E) is lowered, the
pump starts operating.
5) The moment the vacuum gauge (1) indicates -1.0 bar, open lever (F) on the side so that it will be possible to start suction
from the containers through the hose. When the operation is complete, turn the VAC control knob to the preset value.
6) Tighten ring nut (C) on the valve immediately to prevent air return to the container.
CREATING VACUUM INSIDE EXTERNAL CHANNELLED BAGS
1) Switch the machine On and set the sealing value using the SEAL control knob.
2) Check lever (G) of the JARS (if installed) valve to ensure it is closed.
3) Turn the VAC control knob to the OFF position.
4) Place the bag about 20mm beyond the sealing bar (H) in a specular position, then start up the machine by lowering lid (I).
5) When vacuum creation inside the bag is complete, i.e. the vacuum gauge indicates -1.0 bar, press STOP.
The bag will be sealed and the cycle will be complete with devacumation and opening of the lid.
WARNING!
THIS OPERATION IS ONLY POSSIBLE WITH CHANNELLED BAGS.
GB
G
•
CLOSED
Operation and maintenance manual / Ed. 02 - 2006
•
A
•
B
D
•
1
CHANNELLED
BAG
•
E
•
•
•
H
56
VACUUM CHAMBER
PACKAGING MACHINES
C
•
F
OPEN
•
CLOSED
I
•
C
REV. 00 - Cod.: 1500159