AL-KO Solo Robolinho 1000/100 Mode D'emploi page 38

en
Fault code
Error message
CN001: Tilt sen-
sor
CN002: Lift sen-
sor
CN005: Bumper
deflected
CN007: No loop
signal
CN017: Cal: si-
gnal weak
CN008: Loop si-
gnal weak
CN010: Bad posi-
tion
CN011: Escaped
robot
CN012: Cal: no
loop
CN015: Cal: outs-
ide
CN018: Cal: Colli-
sion
CN038: Battery
38
Possible cause
Max. tilt exceeded
Automatic lawnmower
has been carried
Slope too steep
Cover has been deflected
upwards by lifting or by a
foreign body.
Automatic lawnmower has
encountered an obstacle
and cannot free itself (colli-
sion close to base station).
No loop signal.
Fault during calibration, loop
signal too weak.
Loop signal weak.
Automatic lawnmower is
outside loop.
Automatic lawnmower has
left field.
Fault during calibration, au-
tomatic lawnmower could
not find loop.
Fault during calibration, colli-
sion
Battery flat.
Boundary cable defective,
automatic lawnmower does
not find base station.
Solution
Place automatic lawnmower on a flat surface and
acknowledge fault.
Remove foreign body.
Check base station power supply
Check loop
Disconnect and reconnect transformer
Check base station power supply
Check loop, it has possibly been buried too
deep
Disconnect and reconnect transformer
Place automatic lawnmower in mowing area
Loop crossed-over
Check routing of loop (curves, obstacles, etc.)
Place automatic lawnmower at right angles to
loop, automatic lawnmower must be able to
drive over loop
Check base station power supply
Check loop
Disconnect and reconnect transformer
Loop cable crossed-over
Remove obstacle
Check base station for obstacles
Check base station charging contacts
Loop too long, too many islands
Automatic lawnmower has got stuck
Check boundary cable for interruptions, if ne-
cessary have it tested by an AL-KO service part-
ner.
Troubleshooting
Robolinho 1000/100
®