AL-KO Solo Robolinho 1000/100 Mode D'emploi page 31

Start-up
Language selection
[ Select language ]
English
Deutsch
The corresponding language only needs to be
selected here during the initial start-up.
1 Use the [arrow keys] (3-3) to select the requi-
red language.
2 Confirm with the [multifunction key] (3-5).
After confirming, the LCD display (3-1)
shows [Enter registration PIN].
PIN code
Entering the factory-set PIN code
The factory-set PIN code only needs to be entered
during the initial start-up. The factory-set PIN code
is [0000].
[ Registration ]
Enter PIN
****
1 Use the corresponding [arrow keys] (3-3) to
select the corresponding digits and confirm
each one with the [multifunction key] (3-6).
2 Enter the next 3 required digits in the same
way.
Following this, the LCD display (3-1)
shows the [Change PIN] dialogue box.
Changing the PIN code
1 Enter a new PIN and repeat.
After this, the LCD display (3-1) shows
the [Date dialogue box].
Setting or changing the date
Enter the date and time correctly, because further
programming depends on the date and time.
456403_a
Confirm
[ Enter the date
DD.MM.YYYY
13.06.2013
1 Use the corresponding [arrow keys] (3-3) to
select the corresponding digits and confirm
each one with the [multifunction key] (3-5).
After confirming, the LCD display (3-1)
shows [Time dialogue box].
ADVICE
When entering the year (YYYY), it is only
necessary to enter the last two digits be-
cause the first two 20XX are preset.
Setting or changing the time
[ Enter time ]
24 hour format
7:00
Abort
1 Use the corresponding [arrow keys] (3-3) to
select the corresponding digits and confirm
each one with the [multifunction key] (3-5).
Following this, the LCD display (3-1)
shows the [Uncalibrated] status window.
Calibration
For calibration, set up the Robolinho accordingly
(12-3)
13.06.2013
! Warning !
Drive starts
Charge 80%
1 The automatic calibration procedure starts
when the [START key] (3-4) is pressed.
The [Drive starting] warning flashes on
the LCD display (3-1).
]
Confirm
Confirm
12:15
31