AL-KO Solo Robolinho 1000/100 Mode D'emploi page 29

Assembly
Checking the connection
Once the cables have been connected, the LEDs
(7-1) and (7-2) must light up. If this is not the
case, pull out the mains plug and check if all plug
connections and cables are correctly seated; also
check them for damage.
Yellow LED (7-1)
lights up if the base station is connected to the
transformer and there is an electrical power
supply to the transformer.
flashes when the Robolinho is charging.
456403_a
Green LED (7-2)
lights up when the boundary cable is laid cor-
rectly and the loop is OK.
flashes and then goes out if the loop of the
boundary cable is not OK.
ADVICE
The battery has been tested according
to the UN handbook. Therefore, it is not
subject to national and international re-
gulations governing substances of con-
cern, whether it is an individual part or
has been installed in the machine.
29