Surface Maintenance - Zephyr Tornado Mini AK8400AS Guide D'utilisation, D'entretien Et D'installation

SURFACE MAINTENANCE:

Do not use corrosive detergents, abrasive detergents or oven cleaners.
Do not use any product containing chlorine bleach or any product containing chloride.
Do not use steel wool or abrasive scrubbing pads which will scratch and damage surface.
Cleaning Stainless Steel
Clean periodically with warm soapy water and clean cotton cloth or micro fiber cloth. Always rub in the
direction of the stainless steel grain. To remove heavier grease build up use a liquid degreaser detergent.
After cleaning use a non-abrasive stainless steel polish/cleaners, to polish and buff out the stainless luster and
grain. Always scrub lightly, with clean cotton cloth or micro fiber cloth and buff in the direction of the stainless
steel grain.
Aluminum Mesh Filters
The aluminum mesh filters installed by the factory are intended to filter out residue and grease from cooking.
They need not be replaced on a regular basis but are required to be kept clean.
Remove and clean by hand or in dishwasher using a non-phosphate detergent. Discoloration of the filter
may occur if using phosphate detergents, or as a result of local water conditions - but this will not affect filter
performance. This discoloration is not covered by the warranty. Spray degreasing detergent and leave to
soak if heavily soiled.
Dry filters and re-install before using hood.
Installing Metal Mesh Filter, FIG 5:
1. Place back of filter into channel on left side of Power Pack.
2. Pull filter handle towards left side of Power Pack.
3. Pivot filter up and lock into place.
Hood Model: Part No.
AK8400AS 50200054
1
Qty. to Order
1
2
3
FIG 5
12
www.zephyronline.com