Zephyr Tornado Mini AK8400AS Guide D'utilisation, D'entretien Et D'installation page 12

!
CAUTION: At least two installers are
required due to the weight and size of the
hood.
1. Install optional AK084xAS Stainless Steel Liner. Review
manual included with liner for more details.
2. If no liner is used cut out an opening in the bottom of the
cabinet by following the dimensions in FIG 1.
3. Remove aluminum mesh filter.
4. Lift Power Pack into opening and ensure locking clip has
locked into position. (locking clip is located on left side of
Power Pack. FIG 2
5. Fasten (2) M4 screws into the rear long side of Power
Pack. If a liner is used the screws will go through the
Power Pack mounting holes, then the liner and into the
wood base. note: Wood blocking may need to be added
to cabinet base if additional support is needed. see FIG 3
and FIG 4
6. Remove 4 screws from Power Pack face plate. The face
plate will drop down and hang by internal chains. Access to
front long side of Power Pack is now available. Fasten (2)
M4 screws into the front long side of Power Pack.
7. Re-install Power Pack face plate by (4) previously
removed screws.
8. Install duct work and seal with duct tape.
9. Install electrical.
10. Remove all packing materials before using Power
Pack. Switch power on and check for leaks around duct
tape.
11. Install aluminum mesh filter.
wood base wood base
metal or other non
combustible material
10
www.zephyronline.com
19 "
3/4
C/L
cabinet bottom cut-out size
FIG 1
front view
Ductwork Ductwork
locking clip
mounting holes
FIG 2
right side view
Ductwork
wood base wood base
2" minimum 2" minimum
secure (2) M4 screws to mounting
holes on each long side of Power Pack
FIG 3
Power Pack
Stainless Steel Liner
FIG 4
C/L