Surface Maintenance - Zephyr SienaZSI-E30AS-ES Guide D'utilisation, D'entretien Et D'installation

SURFACE MAINTENANCE:

Do not use corrosive detergents, abrasive detergents or oven cleaners.
Do not use any product containing chlorine bleach or any product containing chloride.
Do not use steel wool or abrasive scrubbing pads which will scratch and damage surface.
Cleaning Stainless Steel
Clean periodically with warm soapy water and clean cotton cloth or micro fiber cloth. Always rub in the
direction of the stainless steel grain. To remove heavier grease build up use a liquid degreaser detergent.
After cleaning use a non-abrasive stainless steel polish/cleaners, to polish and buff out the stainless luster
and grain. Always scrub lightly, with clean cotton cloth or micro fiber cloth and buff in the direction of the
stainless steel grain.
Baffle Filters
The baffle filters installed by the factory are intended to filter out residue and grease from cooking. They
need not be replaced on a regular basis but are required to be kept clean.
Remove and clean by hand or in dishwasher on low heat. Spray degreasing detergent and leave to soak if
heavily soiled.
Dry filters and re-install before using hood.
Removing Baffle Filters
1. Push in on spring loaded handle
2. Pull down on filter hande to remove filter
Should filters wear out due to age and prolonged use,
replace with following part number:
Hood Model:
ZSI
Part No. Qty. to Order.
50200050 2
13