Yakima JayHook Instructions De Montage page 3

MAke sure the cArrIers sIt vertIcAllY on the bArs.
OK
(longer bolts)
tIGhten the
knobs.
loAD the boAt, AnD tIe It DoWn.
• Loop strap around hoop of JayHook.
• Bring straps up and over boat so that they
hang in front of the boat.
secure strAPs.
Press open buckle and
insert end of strap.
Instruction #1035832A-3/21
OK
In some cases, the bracket and
the bail may not be parallel.
bolts Must not eXtenD Above
If bolts extend above the knob,
you must use the shorter bolts.
Adjust foam pads to support
boat at contact points.
Note: Some lacquer hull
finishes may stick to pads.
Protect with soft cloth.
• To tighten straps,
hold and pull.
• Secure the loose
ends.
the knobs.
• Slide buckle up so that it hangs at top edge of boat.
• Thread end of strap around tower or crossbar.
If the bolts seem
too short, use
the longer bolts
included in this kit.