Safety Notes; Important Notes; Functions; Operating Instructions - Trix H0 74 Serie Mode D'emploi

Safety Notes

• This model is only to be used with the operating system it
is designed for.
• Analog max. 15 Volts DC, digital max. 22 volts AC.
• This model must not be supplied with power from more
than one power pack.
• Please make note of the safety notes in the instructions
for your operating system.
• The feeder track must be equipped to prevent interference
with radio and television reception, when the model is to
be run in conventional operation. The E611 655 interfe-
rence suppression set is to be used for this purpose. The
interference suppression set is not suitable for digital
operation.
• WARNING! Sharp edges and points required for operation.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• The LEDs in this item correspond to Laser Class 1 accor-
ding to Standard EN 60825-1.

Important Notes

• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• Please see your authorized Trix dealer for repairs or spare
parts.
• Disposing: www.maerklin.com/en/imprint.html
• The warranty card included with this product specifies the
warranty conditions.

Functions

• This model is designed for operation with H0 2-rail
DC systems (track according to NEM standards) with
conventional DC power packs.
• This model comes equipped with a Trix
connector for digital operation and can have the
Märklin locomotive decoder 60972 installed in it.
• Trix motor vehicles must not be operated on
digital systems without an built-in engine decoder (Motor
can be damaged!).
• Headlights change over with the direction of travel.
• Minimum radius for operation is 360 mm / 14-3/16".

Operating Instructions

• Information about retrofitting a digital decoder:
This locomotive has an electronic circuit plugged into the
digital connector instead of a connector plug on the basic
circuit board in the tender. This electronic circuit is only
required in analog operation. It must be removed when
retrofitting the locomotive with a digital decoder. See also
Page 18.
• This starter set is delivered to the dealers with Relex
couplers mounted on the locomotive and cars. Due to
various feedback, the use of this coupler on beginner
models appears to be more convenient, because the
coupling behavior is easier to work with than with the
Märklin close coupler. This especially ensures the play
value for our new customers. Naturally, we also include
the Märklin close couplers so that the experienced model
railroader can install them in order to be able represent
more prototypical operation on his model railroad layout.
21
7