Waldbeck Yukon Mode D'emploi page 41

5. JEWELRY mode test
• Press the MODE "+" button again, the operation mode cursor points to
JEWELRY, and the first target discrimination cursor at the lower cursor
are extinguished.
• Sweep the four metal samples about 7 to 10cm above the search coil in
turn.
• When sweeping the iron nail, the detector will not respond, meaning the
"iron" is eliminated.
• When sweeping the other three samples, the response of the detector is
the same with the ALL METAL mode.(See Fig.11, take 1 zinc coin as an
example):
6. Memory mode test
a. Press the MODE button again, the operation mode cursor points to
MEMORY. The target ID cursor(upper cursor)is extinguished, and the
target identification cursor (lower cursor)is all lighted.
b. Imagine to search the 25 ¢ silver coin, but eliminate other metals,
carry out the following operations: Sweep the 25 ¢ silver coin about
7-10 cm above the search coil, the target identification cursor that the
25¢ silver coin corresponding to is still lighted, but other identification
cursors are all extinguished.
EN
41