Waldbeck Yukon Mode D'emploi page 34

EN
34
• Mode indication cursor: indicate the operation modes, four kinds. Make
a switch through the MODE button.
• Target ID pattern: It is located above the LCD screen. It indicates the
target metals looking for. When detecting a metal target, the target ID
cursor (upper scale) will appear below the such metal patterns or the
words.
• Target ID cursor (upper scale): it is in the shape of  . The upper scale
consists of 6 segments. When the target ID cursor is lighted, which
indicates the probable type of the detected metal.
The three kinds of prompted signal, corresponding to the target ID cursor.
See the table below:
Low pitch Mediant
iron Pull-tab
S-cap
Note: affected by the soil composition, as the same material metal in the
different soil, the position of the target ID cursor may have a change.
Target identification cursor(lower scale): It is in the shape of , 6 segments
making up the lower cursor, which indicates the material types of the
detected target objects. In the ALL-METAL mode, the 6 segments are all
lighted. While in other modes, when a certain target identification cursor is
extinguished, which indicates this type of metal isn't in the detection range,
which means this type of metal is eliminated.
In the PINPOINT mode, the Target identification cursor is useless.
Target Digit Cursor: double digit, 10-99 indicates the material of the metal.
When detecting, the digit may have some changes, which depends on the
composition of the target, the size, the shape, the distance from the search
coil and the speed of scanning. The surrounding soil can also affect the value.
Refer to the following table as a preliminary guide.
Gold has a wide numerical range, a thin ring is about 45, and a rough ring and
gold coin may up to 70-80.
High pitch
Copper coins