Waldbeck Yukon Mode D'emploi page 30

EN
30
ASSEMBLY
1. Loosen the two triangular fasten buttons under the control box, insert to
the bracket , and lock the two triangular buttons. See Fig.1
2. Press down the silver shrapnel on the plastic stem, and insert it to the
black aluminum stem. When the silver shrapnel popping up from the
black aluminum stem, you can use it. The black aluminum stem is with
four holes, for you to adjust the length of the connecting rod, so that you
can comfortably erect and straighten your arms, and keep the search coil
be away from the ground about 1/2 inch. See Fig.2 , 3.
3. Wind the electronic line on the search coil around the aluminum stem,
keep the elastic moderate, so that the cable won't sway.
4. Relax the nuts at the two ends of the search coil, and adjust the location
of the search coil, to let the search coil be parallel with the ground. Be
careful not to mistake the location of the search coil(See Fig.3).
Fig. 1
Fig. 2
Fig. 2