Measurement Using Tricheck - A&D Medical Life Source UA-1030T Manuel D'instructions

Masquer les pouces Voir aussi pour Life Source UA-1030T:

Manuel d'instructions (106 pages)

Table des Matières

Les langues disponibles

TAKING YOUR BLOOD PRESSURE

5. Press the

button. All of the display

START

segments are displayed. Zero (0) is displayed

blinking briefly. The display changes, as indicated

in the figure at the right, as the measurement

begins. The cuff starts to inflate. It is normal for

the cuff to feel very tight. A pressure bar indicator

is displayed, on the left edge of the display,

during the inflation.

Note: If you wish to stop inflation at any time, press the START

button again.

6. When inflation is complete, deflation starts

automatically and

blinks, indicating that the

measurement is in progress. Once the pulse is

detected, the mark blinks with each pulse beat.

Note: If an appropriate pressure is not obtained, the device

starts to inflate again automatically. To avoid re-inflation,

Press

START

see "Measurement with the SET Pressure" on the next page.

7. When the measurement is complete, the systolic

and diastolic pressure readings and pulse

All of the display

rate are displayed. The device announces the

segments displayed

measurement results. The cuff exhausts the

remaining air and deflates completely.

8. Press the

button to turn the device off.

START

After one minute of non-operation, the device will

turn off automatically.

Zero display

9. The reading is then stored into memory. See page

Starts inflation

E-18 for more details about the memory function.

10. Remove cuff and make a note of blood pressure and pulse rate on the

chart in the back of this manual, indicating date and time of measurement.

Additional logbook charts can be downloaded and printed for free at

www.andmedical.com or in Canada at www.autocontrol.com. We advise

that you record the date and time after each measurement becaue an

Pressurizing

accurate blood pressure history relies not on single or sporadic readings,

but on a pattern over time.

E-13

Press

START

All of the display

segments displayed

Zero display

Starts inflation

Pressurizing

Measurement

in progress

Systolic pressure

Diastolic pressure

WHO classification

Pulse rate

Exhausts remaining

air automatically

A&D Medical (Toll-Free): 1-888-726-9966

1. Press the

button.

START

All of the display segments are displayed.

Zero (0) is displayed blinking briefly and the

first measurement starts.

2. When the measurement is complete, the

systolic and diastolic pressure readings

and pulse rate are displayed, then a

one-minute countdown starts for the second

measurement.

3. After one minute, the second measurement

starts.

4. When the measurement is complete, the

average readings of the first and second

measurements are displayed, then a

one-minute countdown starts for the third

measurement.

5. After one minute, the third measurement

starts.

6. When the measurement is complete, the

average readings of the three measurements

are displayed and stored in memory.

Notes:

During the measurement, the TriCheck

symbol is displayed.

To cancel the measurement, press the START

button. In this case, no data is stored in

memory.

When the cuff fit error symbol appears during the first measurement, cancel

the measurement, reapply the cuff correctly and start a new measurement.

After measurement, the average data of the three measurements is stored in

memory. No data will be stored, when canceling the measurements, or before

completion of the third measurement.

In Canada - Auto Control Medical (Toll-Free): 1-800-461-0991