What Display Symbols Mean - A&D Medical Life Source UA-1030T Manuel D'instructions

WHAT DISPLAY SYMBOLS MEAN

Symbols that are printed on the device case
Symbols Function / Meaning
Standby and turn the device on.
Battery installation guide
R6(AA)
Direct current
SN Serial number
2010 Date of manufacture
Type BF: Device, cuff and tubing are
designed to provide special protection
against electrical shock.
EC directive medical device label
0366
WEEE label
Manufacturer
EU-representative
EC REP
Symbols that appear on the display
Symbols Function / Meaning
Appears while measurement is in
progress. It blinks when the pulse is
detected.
Irregular Heartbeat symbol (I.H.B.)
Appears when an irregular heartbeat
is detected during measurement.
TriCheck mode
Takes three consecutive
measurements automatically and
displays the average values of the
three measurements.
Appears when a body or arm
movement is detected.
E-5
Recommended Action
Recommended Action
Measurement is in
progress. Remain as still
as possible.
The reading may yield
an incorrect value. Take
another measurement.
Remain still during
measurement.
A&D Medical (Toll-Free): 1-888-726-9966
Symbols Function / Meaning
Appears during measurement when
the cuff is applied loosely.
Previous measurements stored in memory
Average data
The battery power indicator during
measurement.
Full Battery
The battery is low when it blinks.
Low Battery
Unstable blood pressure due to
movement during measurement.
The systolic and diastolic values are
within 10 mmHg of each other.
The pressure value did not increase
during the inflation.
The cuff is not applied correctly.
The pulse is not detected correctly.
PUL. DISPLAY ERROR
Blood pressure monitor internal error
Systolic blood pressure in mmHg
SYS.
Diastolic blood pressure in mmHg
DIA.
Pulse per minute
PUL./min.
AM Data taken between 4:00 and 9:59
Data taken between 18:00 and 1:59
PM
Pressure settings
Indicates the pressure value as set
by the user.
In Canada - Auto Control Medical (Toll-Free): 1-800-461-0991
WHAT DISPLAY SYMBOLS MEAN
Recommended Action
The reading may yield an
incorrect value. Apply the
cuff correctly, and take
another measurement.
Replace all batteries with new
ones when the mark blinks.
Take another measurement.
Remain still during
measurement.
Apply the cuff correctly,
and take another
measurement.
Remove the batteries and
press the START button,
and then install the batteries
again. If the error still
appears, contact the A&D.
E-6