Horizontal Adjustment Of The Headlight Beam; Bulbs; Changing The Turn Indicator Bulbs - APRILIA SCARABEO 250 Mode D'emploi

2
HORIZONTAL ADJUSTMENT OF
THE HEADLIGHT BEAM
To adjust the headlight horizontal beam:
Loosen the two screws
u
screwdriver (2).
Move the beam to the right or left
u
according to the direction of travel.
Tighten the two screws (2).
u
68 use and maintenance Scarabeo 250

BULBS

Carefully read page 51 (MAINTENANCE)
Risk of fire.
2 K e e p f u e l a n d o t h e r f l a m m a b l e
s u b s t a n c e s a w a y f r o m e l e c t r i c
components.
Before changing a bulb, set the ignition
switch to position " " and allow a few
minutes for the bulb to cool down.
Wear clean gloves or use a clean, dry
cloth to handle the new bulb.
Do not put your fingerprints on the
bulb, as this may lead to overheating
with a
and failure.
If you have handled the bulb with bare
hands, clean it with alcohol to avoid any
damage.
DO NOT PULL ON THE WIRES.
NOTE
Before changing a bulb, check
the fuses, see page 67 (CHANGING THE
FUSES)
4
2
3
1
CHANGING THE TURN INDICATOR
BULBS
Carefully read on the side (BULBS)
To change the bulbs:
NOTE
The following information applies
to all turn indicators.
Unscrew and remove the screw (1).
u
Proceed with care.
Do not damage the tabs and/or their
seats.
Remove the lens (2).
u