Placing The Vehicle On The Stand; Side Stand - APRILIA SCARABEO 250 Mode D'emploi

1
2
Stop the vehicle, see
u
(STOPPING)
Set the engine stop switch (1) to position
u
" ".
W i t h t h e e n g i n e s t o p p e d a n d t h e
ignition switch in position "
battery may run down.
Rotate the key (2) and set the ignition
u
switch (3) to position " ".
Position the vehicle on the stand, see on
u
the side (PLACING THE VEHICLE ON
THE STAND)
NOTE
It is not necessary to close the
fuel tap when the engine is off, since it is
equipped with an automatic closing
system.
50 use and maintenance Scarabeo 250
4
5
3
page 49
Never leave the key in the ignition
switch.
Lock the
u
(STEERING LOCK) and remove the key.
PLACING THE VEHICLE ON THE
" , the
STAND
Carefully read page 49 (PARKING)
CENTER STAND
Grasp the left grip (4) and the passenger
u
grab rail (5).
Push down the stand lever (6).
u
6
steering, see page 31
4
5

SIDE STAND

Grasp the left grip (4) and the passenger
u
grab rail (5).
Risk of falling and overturning.
When the vehicle is straightened from
the parking position to the driving
position, the stand goes automatically
up.
Push on the side stand with your right
u
foot and lower it completely (7).
Lean the vehicle to the side until the
u
stand is resting on the ground.
Turn the handlebar fully to the left.
u
Make sure that the vehicle is stable.
7