Hansgrohe Axor Montreux 16530 Serie Instructions De Montage page 17

Important! The fitting must be installed, flushed
and tested after the valid norms!
Assembly
1 Flush through the supply pipes.
2 Place the mixer including the sealing
washer in position on the basin.
3 Push connection piece over the tails and
tighten with nut.
4 Connect the supply pipes to the isolation
valves; cold right - hot left.
Technical Data
This mixer series-produced with EcoSmart®
(flow limiter).
Rate of flow with EcoSmart:
Rate of flow without EcoSmart:
Operating pressure:
Recommended operating pressure:
MPa
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Test certificate
DVGW
37130XXX
38130XXX
16530XXX
Hansgrohe · Postfach 1145 · D-77761 Schiltach · Telefon +49 (0) 78 36/51-1282 · Telefax +49 (0) 7836/511440
5 l/min 0,3 MPa
9 l/min 0,3 MPa
max. 1 MPa
0,1 – 0,5
1,6 MPa
max. 80° C
65° C
P-IX SVGW
P-IX
9370/IA
P-IX
9377/IA
P-IX
18196/IA
E-Mail: info@hansgrohe.com · Internet: www.hansgrohe.com
English
Hansgrohe mixers can be used together with
hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0,15 MPa.
If the continuous water heater causes any
problems or there is not enough flow of water,
the EcoSmart® (5a) located behind the aerator
must be removed.
Spare parts see page 3 + 4
1 handle Terrano
2 handle Uno
3 aerator cpl.
4 aerator cpl.
5 shut off unit
6 fixing set
7 connection hose
8 supply pipe
9 handle Monteux
10 sleeve
11 shut off unit
12 aerator cpl.
13 fixing set
XXX = Colors
000 chrome plated
810 satinox
820 brushed nickel
830 polished nickel
ACS
X
X
NF WRAS
X
37298XXX
96318XXX
96336XXX
96673XXX
94149000
96016000
13099XXX
96786000
16597XXX
97993XXX
94009000
98583XXX
96078000
KIWA
5