Work Piece Support - DeWalt DW930 Guide D'utilisation

FIG. 6
DO support board or
FIG. 8
panel NEAR the cut.
0
FIG. 9
FIG. 7
0
SUPPORT
DON'T support board or
panel AWAY from the cut.
10
6. Confirm the accuracy of the setting by checking the squareness of
an actual cut on a scrap piece of material.
Kerf Indicator
The front of the saw shoe has a kerf indicator for vertical and bevel
cutting. This indicator enables you to guide the saw along cutting lines
penciled on the material being cut. The indicator lines up with the left
(outer) side of the saw blade, which makes the slot or "kerf" cut by the
moving blade fall to the right of the indicator. Guide along the penciled
cutting line so that the kerf falls into the waste or surplus material..

Work Piece Support

Figure 6 shows proper sawing position. Note that hands are kept away
from cutting area. To avoid kickback, DO support board or panel NEAR
the cut, (FIG. 7). DON'T support board or panel away from the cut,
(FIG. 8).
WARNING: It is important to support the work properly and to hold
the saw firmly to prevent loss of control which could cause personal
injury. FIG. 6 illustrates typical hand support of the saw. ALWAYS
TURN OFF TOOL AND REMOVE BATTERY BEFORE MAKING ANY
ADJUSTMENTS!
Place the work with its "good" side–the one on which appearance is
most important–down. The saw cuts upward, so any splintering will be
on the work face that is up when you cut it.
FIG. 10
SWITCH LOCK
OFF RELEASE
BUTTON
TRIGGER
SWITCH