Zephyr Essentials Vortex AK9028AS Guide D'utilisation, D'entretien Et D'installation page 5

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING
TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK.
CAUTION
attics, crawl spaces or garages.
OPERATION
and loose clothing.
The manufacturer declines all responsibility in the event of failure to observe the instructions given here for installation,
maintenance and suitable use of the product. The manufacturer further declines all responsibility for injury due to
negligence and the warranty of the unit automatically expires due to improper maintenance.
*NOTE: Please check www.zephyronline.com for revisions before doing any custom work.
ELECTRICAL REQUIREMENTS
Important:
Observe all governing codes and ordinances.
It is the customer's responsibility:
- To assure that the electrical installation is adequate and in conformance with National Electrical Code, ANSI/NFPA 70
latest edition* or CSA standards C22.1-94, Canadian Electrical Code, Part 1 and C22.2 No.0-M91 - latest edition** and
all local codes and ordinances.
ground path is adequate.
Do not ground to a gas pipe.
Do not have a fuse in the neutral or ground circuit.
*National Fire Protection Association Batterymarch Park, Quincy, Massachusetts 02269
** CSA International 8501 East Pleasant Valley Road, Cleveland, Ohio 44131-5575
This appliance requires a 120V 60Hz electrical supply and connected to an individual properly grounded branch circuit
protected by a 15 or 20 ampere circuit breaker or time delay fuse. Wiring must be 2 wire with ground. Please also refer to
Electrical Diagram on product.
AK9028AS / AK9034AS - Max. 315W @ 3 Amps
AK9028AS290 / AK9034AS290 - Max. 130W @ 1.5 Amps
AK9028AS-ES / AK9034AS-ES - Max. 96W @ 1.2 Amps
and install appropriate connector if necessary.
3

Publicité

Table des Matières
loading

Table des Matières