Zephyr Essentials Vortex AK9028AS Guide D'utilisation, D'entretien Et D'installation page 12

CAUTION: At least two installers are
required due to the weight and size of the
hood.
If possible, power up and test all functions prior to installation.
during installation to prevent scratches or damage
to the stainless steel.
2. Prepare custom hood enclosure by following the
dimensions in FIG. 1.
3. Install liner into custom hood. FIG. 2, Page 11.
WARNING: Make sure the surface you are securing the
liner to is capable of holding the weight of AK90. Failure
to do so may cause personal injury or damage to cooking
surface or counter. Wood blocking may need to be added
to cabinet base if additional support is needed.
4. Secure front panel to custom hood. FIG. 3, Page 11
5. Finalize electrical and duct work. Seal duct work
Note: If access to the top of the liner is not available
after installation, duct work and electrical connection
may need to be installed prior to installing the liner.
6. Power on the liner, check for leaks around duct tape
and test for proper operation.
The ducting from this fan to the outside
of the building has a strong effect
use of the fan. Use the shortest,
straightest duct routing possible for
best performance, and avoid installing
the fan with smaller ducts than
recommended. Insulation around the
ducts can reduce energy loss and
inhibit mold growth. Fans installed with
existing ducts may not achieve their
Recommended
Side Panel Thickness:
-
1/
Plywood Base
Custom Hood
Model Exterior Width
AK9028AS 30 inches
AK9034AS 36 inches
Cut-Out
Width (C)
Model
AK9028AS
26- "
5/8
AK9034AS
*Dimension does not include 3/8" wide flange around liner.
**Assumes backboard thickness of 3/8"
10
www.zephyronline.com
3/4''
FIG. 1
Inside Inside Depth* (B)
Width* (A)
Without Backboard
28 "
1/2
17 " - 20
1/2 1/2
34 "
1/2
Rear Base
Cut-Out
Depth
Depth (D)
Without Backboard
10- "
1/2 1- 3/8 "
FIG. 1
3/8" Wide Flange
With Backboard**
" 17 " - 20 "
1/8 1/8
(E)
With Backboard**
1"