U.S.Robotics USR5630B Mode D'emploi page 5

Windows 95/98/Me/XP/Operating Systems
Installation
Step1: Prepare for installation.
NOTE: Before you begin, we recommend you uninstall any other modems
you have in your system. Refer to your previous modem's
documentation for instructions.
Write down your new U.S. Robotics modem's serial number, which is
located on the white bar code sticker on the modem and on the
modem's box. If you ever need to call our Technical Support
department, you will need this number to receive assistance.
Step 2: Connect the modem to the computer.
Shut down your computer and connect the serial modem cable to the
modem and the computer.
Step 3: Connect the modem to an analogue phone line.
Plug one end of the provided phone cord into the jack on the modem
and plug the other end into an analogue phone wall jack.
WARNING:
The phone socket you use must be for an ANALOGUE phone line. Most
office phones are wired through DIGITAL lines. Be sure you know
what type of line you have. The modem will be damaged if you use a
digital phone line.
Step 4: Plug in the modem's power supply.
Plug the power supply into the jack on the modem and the other end
into an electrical outlet. Turn on the modem. The power button
(labelled Power I / O on the modem's underside) is located on the
side of the modem.
NOTE: If the power light does not illuminate, the modem may not be
turned on. Make sure the power supply is connected between the
modem and the electrical outlet.
Step 5: Install the modem drivers.
Turn on your computer. After the New Hardware Wizard detects your
modem, insert the Installation CD into your CD-ROM drive. Follow
the onscreen prompts to complete the installation.
Step 6: Install the communications software.
Reinsert the Installation CD into the CD-ROM drive. An interface
will appear that will enable you to install ControlCenter, Internet
Call Notification, and Phonetools/Winphone software and view User
Guides for your modem. (If the interface does not appear
automatically, click Windows Start and then click Run. In the Run
dialog box, type D:\setup.exe. If your CD-ROM drive uses a
different letter, type that letter in place of "D").
5