Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INTRODUCTION
First of all we would like to thank and congratulate you for the purchase of this product manufactured by
Golmar.
The commitment to reach the satisfaction of our customers is stated through the ISO-9001 certification
and for the manufacturing of products like this one.
Its advanced technology and exacting quality control will do that customers and users enjoy with the
legion of features this system offers To obtain the maximum profit of these features and a properly wired
installation, we kindly recommend you to expend a few minutes of your time to read this manual.
INDEX
Introduction ...........................................81
Index.....................................................81
Starting recommendations
Safety precautions...................................82
Door panel installation ................................
Description..........................................84
Embedding box installation
Electronic modules assembly
Placing the nameplate labels
Push buttons wiring
Push buttons coding
EL500/V2 Plus configuration
Lamps wiring
....................................... 93
Closing the door panel
Description..........................................95
End of line / amplifying video signal ........96
Identification label................................96
STARTING RECOMMENDATIONS
The installation and handling of this equipment must be performed by authorised personnel.
Install or modify the equipment without the power connected.
Do not use excessive force when tightening the power supply connection block screws.
The entire installation must be at least 40 cm. away from any other installation.
Before connecting the system, check the connections between door panel, distributors, monitors,
telephones and the transformer connection Do always follow the enclosed information
When starting the equipment for the first time, or after a modification, the system will remain inactive
for around 45 seconds due to the initial busy channel time
Use Golmar RAP-2150 cable
Do always follow the enclosed information
.
....................... 81
........................ 82-83
................................... 83
................... 85
....................86
................. 87
................................. 88
..................89
..........................89-90
..............................91
................. 92
.............................92
................................. 93
......................... 94
......................... 94
.......................... 94
..................................
...........................96
.
Monitor connection block description
Programming
Telephone
Description........................................100
Connection terminals, JP3 configuration
Programming
Replacement ..........................................
Minimum requirements............103-104
Installation of replacement ...................
Cable & sections chart (one access) ..104
Cable & sections chart (several accesses) .105
Call from the apartment door
Additional monitor/telephone or call repeater
Auxiliary devices activation
Without a distributor
With a 1 line distributor
With a 4 line distributor
With a.c lock release...................117-118
Notes...........................................120-122
Compliance.........................................
.
.
.
...............................98
.......................................99
.................................
...........................100
.........................101
.....................................102
..................................
.............106
...............106
.................. 108
...................................
....................109-110
.................111-112
.................113-116
..........................119
.
81
......97
100
107
123
Publicité
Chapitres
Table des Matières
