Cleaning And Care; Noise Development; Technical Data - AEG PROFI-FOEN HTD 5584 Mode D'emploi

Commissioning
• Fully unwind the mains cable.
• Fit on a nozzle.
• You can dry single hair locks by concentrating the
flow of hot air with the hairdressing nozzle.
• The diffuser is the ideal solution to dry curly hair
without losing volume.
• In order to replace the attachment, first remove the old
attachment by pulling it off and then pushing on the new
one until it clicks into place.
• Only connect the machine to a properly installed safety
socket.
Setting the Temperature Level ( switch):
Position 1: low temperature
Position 2: medium temperature for gentle drying
and shaping.
Position 3: high temperature for rapid drying.
Setting the Temperature Level (
Position 0: off
Position 1: gentle stream of air
Position 2: strong stream of air
COOL SHOT (Cold Air)
With this switch you can stop the heating
process.
Hold the button down in this position according to the
desired interval length. When the button is released it
returned automatically to the initial position.
Switch-off
• After use, move the right-hand switch ( ) to the "0"
position and remove the mains plug from the socket.
• Leave the device to cool before putting it away!
• Hang the device up by the suspension eye.
Ionisation function –
reducing electrically charged hair
The dryer is also equipped with an ioniser, which when
switched on gives off negative ions with the air that is ex-
pelled. This process helps to protect the hair when it is being
dried while simultaneously helping to improve hair structure,
increase the volume of the hair, produce a silky sheen and
also reduce the static charge of the hair.
This process is particularly gentle for stressed hair.
Turn the hairdryer on by moving the " " switch to the "I"
position. The control lamp lights up in green. To turn the
device off, move the switch to "0".
Mains Cable
• The mains cable should only be wound up loosely.
• Never tie the cable tightly round the device, as over time
this may result in the cable breaking.
• Check the mains cable regularly for damage.

Cleaning and care

WARNING:
• Before cleaning remove the mains lead from the
socket.
• Under no circumstances should you immerse the
device in water for cleaning purposes. Otherwise this
might result in an electric shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
Clean the housing with a soft, dry cloth without additives.
switch):
Air Intake Grill
Please clean the grill on the air intake side of the hairdryer
regularly in order to avoid excessive temperatures as a result
of heat accumulation.
• Unscrew the grille in an anticlockwise direction.
• Remove any dirt that is present.
• If necessary, a fine brush can be used.
• Turn the grille tight in a clockwise direction.

Noise development

The sound pressure level in the ear of an operator (LpA) was
measured according to DIN EN ISO 3744.
Sound pressure level detected: 85 dB(A) (no limit)

Technical Data

Model: ................................................................................HTD 5584
Power supply: .............................................................230 V~; 50 Hz
Power consumption:............................................................ 2200 W
Protection class: ................................................................................II
Net weight: .............................................................................0.55 kg
The right to make technical and design modifications in
the course of continuous product development remains
reserved.
This device has been tested according to all relevant current
CE guidelines, such as electromagnetic compatibility and low
voltage directives, and has been constructed in accordance
with the latest safety regulations.
English
29