Maintenance And Care; Noise Development - AEG FOEN HT 5650 Mode D'emploi

Electrical Connection
• Before inserting the plug into the socket, make sure that
the mains voltage to be used matches that of the device.
You can find this information on the nameplate.
• Connect the appliance to a properly installed earthed
socket.
Use
Slide the switch on the handle to the desired heat / blower
setting:
Position 0: Off
Position I: Moderate airflow and low temperature
Position II: Strong airflow and medium temperature
Position III: Strong air flow and high temperature
COOL SHOT (Cold Air)
Switch : With this switch you can stop the heating
process.
Hold the button down in this position according to the de-
sired interval length. When the button is released it returned
automatically to the initial position.
Ionisation function – reducing electrically charged hair
The dryer is also equipped with an ioniser, which when
switched on gives off negative ions with the air that is ex-
pelled. This process helps to protect the hair when it is being

Maintenance and care

WARNING:
• Before cleaning remove the mains lead from the socked.
• Under no circumstances should you immerse the device in water
for cleaning purposes. Otherwise this might result in an electric
shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
Clean the housing with a soft, dry cloth without additivesl.
Air Intake Grill
Please clean the grill on the air intake side of the hairdryer
regularly in order to avoid excessive temperatures as a result
of heat accumulation.
dried while simultaneously helping to improve hair structure,
increase the volume of the hair, produce a silky sheen and
also reduce the static charge of the hair.
This process is particularly gentle for stressed hair.
Switch-off
After use, slide the switch to position "0" and disconnect
from the mains.
Cable rewind function
• Use the automatic cable rewind function only when the
handle is flipped open.
• Hold the plug of the mains cable with one hand. At the
same time, press the button with your other hand to
rewind the cable.
CAUTION:
The plug can flap around. Only release the plug after
the cable has been retracted completely!
Storage
• Leave the device to cool before putting it away!
• To do so, place the appliance onto one side of the hous-
ing or hang it up by the suspension eye.
• The handle can be folded in order to save space during
storage.
• Unscrew the grille in an anticlockwise direction.
• Remove any dirt that is present.
• If necessary, a fine brush can be used.
• Turn the grille tight in a clockwise direction.

Noise development

The sound pressure level in the ear of an operator (LpA) was
measured according to DIN EN ISO 3744.
Sound pressure level detected: 77 dB(A) (no limit)
English
25