Installation Of Accessories; Standards And Guidelines - THERMOBILE IMAC Manuel De L'utilisateur

9

INSTALLATION OF ACCESSORIES

9.1 Flue (fig. 9)
The convector heater has a flue connection.
1. Slide a flue (B) over the connection (C).
Caution
The flue should point upward. Do not let
the flue point sideways. An angle of 45°
is acceptable; the length of the flue
should be at least 3.5 ft.
2. Place a rain cover (A) on the end of the flue.
9.2 Diameter of the flue
/i
Flue (external) IMAC - IMA - G US
Diameter 8 inch
9.3 Air hose
Hoses may be connected to the exhaust opening
of the convector heater to convey hot air
elsewhere.
Caution
Check the temperature resistance of the
hose used. The maximum air
temperature of the duct is 240 °F.
/i
Air hose IMAC
Diameter 24 inch 20 inch 24 inch
Contact your dealer for information about the
maximum resistance and the diameters of the
exhaust hoses, bends, manifolds and hose
clamps.
9.4 Diameters of exhaust hoses
/i
Outlet IMAC
Diameter 24 inch 20 inch 24 inch
9.5 Room thermostat
Refer to the instructions of the thermostat.
IMAC - IMA - G US
IMA 111 IMA 185
IMA 111 IMA 185
40.020.956 - rev. 03 - 2010
10

STANDARDS AND GUIDELINES

THERMOBILE INDUSTRIES B.V., Konijnenberg
80, NL-4825 BD BREDA, the Netherlands,
declare, completely on their own responsibility,
that the product:
INDIRECT NATURAL GAS-FIRED
CONVECTOR HEATERS IMAC 2000S-G US,
IMA 111-G US, and IMA 185-G US
have been designed and built according to the
National Fuel Gas Code ANSI Z223.1/NFPA 54
and the Natural Gas and Propane Installation
Code, CSA B149.1.
Netherlands, Breda,
01-02-2010
B. Posthumus
Managing Director
English
15