Installation Of Accessories; Ec Declaration Of Conformity - THERMOBILE IMAC 1200EC Manuel De L'utilisateur

English
9

INSTALLATION OF ACCESSORIES

9.1 Flue (Fig. 4)
The convector heater has a flue connection.
1. Slide a flue (B) over the connection (C).
Caution
The flue should point upward. Do not let
the flue point sideways. An angle of 45°
is acceptable; the length of the flue
should be at least 1000 mm.
2. Place a rain cover (A) on the end of the flue.
9.2 Diameter of the flue
/i
Flue (external)
Diameter
9.3 Air hose
Hoses may be connected to the exhaust opening
of the convector heater to convey hot air
elsewhere.
Caution
Check the temperature resistance of the
hose used.
Contact your dealer for information about the
maximum resistance and the diameters of the
exhaust hoses, bends, manifolds and hose
clamps.
9.4 Diameters of exhaust hoses
/i
Outlet
Diameter
9.5 Room thermostat
Refer to the instructions of the thermostat.
10

EC DECLARATION OF CONFORMITY

For the EC declaration of conformity, go to
www.thermobile.nl.
22
22
IMAC 1200/1500/2000EC
200 mm
IMAC 1200/1500/2000EC
600 mm
40.021.086 - rev 01 - 2019
40.20.927 - rev. 06 - 2011
ENGLISH
IMAC 1200/1500/2000EC
IMAC 2000 S