Led Display - Tronic TPB 5000 A1 Mode D'emploi

CAUTION
► Use only a USB mains adapter with an output volt-
age of 5 V and an output current of at least 2,1 A
to charge the power bank.
► Always disconnect the charging cable 7 when
charging is complete!
♦ Connect the USB-A plug of the charging cable 7 to
a suitable USB power supply (not supplied).
♦ Connect the USB-C plug of the charging cable 7 to
the USB-C charging port 4 on the power bank.
The charge level LEDs 3 provide a rough estimate of the
charge level during charging:

LED display

One LED is flashing
One LED is on, the second LED is
flashing
Two LEDs are on, the third LED is
flashing
Three LEDs are on, the fourth LED
is flashing
All LEDs are on
■ 12 │ GB │ IE
Charge level
< 25%
25 ‒ 49%
50 ‒ 74%
75 ‒ 97%
98 ‒ 100%
TPB 5000 A1