Bosch RH328VC-36 Consignes De Fonctionnement/Sécurité page 8

160992A0NW 09-14_RH328VC-36 9/3/14 8:08 AM Page 8
Disconnect battery pack
W RNING
from tool or place the
switch in the locked or off position before
making any assembly, adjustments or
changing accessories. Such preventive
safety measures reduce the risk of starting the
tool accidentally.
INSTALLING SDS-plus
Clean the insert shank end of the accessory to
remove any debris, then lightly grease with a
light oil or lubricant.
Insert accessory into the chuck through the
dust shield, while twisting and pushing inward
until it locks automatically into place. Pull
outward on the accessory to be certain it is
locked into the chuck (Fig. 2).
FIG. 2
Disconnect battery pack
W RNING
from tool or place the
switch in the locked or off position before
making any assembly, adjustments or
changing accessories. Such preventive
safety measures reduce the risk of starting the
tool accidentally.
INSTALLING & REMOVING 3-JAW CHUCK
(Not included, available as accessory)
The 3 Jaw Chuck
with SDS Shank
can convert your
tool for use with
straight shank
bits (Fig. 4).
Clean the insert shank end of the accessory to
remove any debris, then lightly grease with a
light oil or lubricant
Insert accessory into the chuck through the
dust shield, while twisting and pushing inward
Assembly
®
ACCESSORIES
DUST
SHIELD
FIG. 4
NOTE: The high efficiency available from the
rotary hammers can only be obtained if sharp
and undamaged accessories are used. The
"cost" to maintain sharp and undamaged
accessories is more than offset by the "time
saved" in operating the tool with sharp
accessories.
REMOVING SDS-plus
Accessories may be hot
W RNING
after use. Avoid contact with
skin and use proper protective gloves or cloth
to remove.
To remove an accessory, pull locking sleeve
backward and pull bit forward. All accessories
should be wiped clean after removing (Fig. 3).
FIG. 3
until it locks automatically into place. Pull
outward on the accessory to be certain it is
locked into the chuck (Fig. 5).
To remove the chuck, pull the locking sleeve
backward (towards the rear of tool), while
pulling the chuck forward.
FIG. 5
3-J W CHUCK
(Not included, available
as accessory)
-8-
®
ACCESSORIES
LOCKING
SLEEVE
LOCKING
SLEEVE