Slip Clutch - Bosch RH328VC-36 Consignes De Fonctionnement/Sécurité

160992A0NW 09-14_RH328VC-36 9/3/14 8:08 AM Page 11
"VARIO-LOCK"
The Vario-Lock position is intended for use
with chipping bits such as bull points, spades,
gouges, etc. Choose a position which is best
suited for your operation.
Turn the mode selector dial, to the "vario-
lock" setting. Next, rotate the locking sleeve,
along with the accessory, to the desired
position. Then turn the mode selector dial to
the "hammer only" setting and slightly turn
the locking sleeve to have it automatically
lock into a definite position (Fig. 11).

SLIP CLUTCH

The tool has a internal pre-set slip clutch. The
output spindle will stop rotating if the accessory
binds and overloads the tool.
When the trigger is released it activates the
electrical brake to stop the chuck quickly. This
is especially useful in the repetitive driving and
removal of screws.
FIG. 11
BRAKE
ELECTRONIC PRECISION
CONTROL (EPC)
EPC assists you when working with impact in
sensitive materials by ensuring slow start-up
and reduced operating speed.
Slide the EPC switch to the desired position:
Position for maximum operating
speed
Position for slow start-up and
reduced operating speed
RAPID SHUT- OFF (ERC)
The rapid shut-off feature enables better
control of the power tool. The power tool shuts
off in case of sudden and unexpected rotation
of the power tool around the drilling axis.
Rapid Shut-off is indicated by flashing of the
worklight on the power tool.
To restart the machine, release the On/Off
switch and then actuate again.
Rapid shut-off can trigger only when the power
tool is running at maximum operating speed
and can rotate freely around the drill bit axis.
-11-
FIG. 12
EPC
SWITCH