Configuring Settings From Your Computer; Setting Up The Optional Heart Rate Sensor; Wearing The Sensor Strap; Pairing The Heart Rate Sensor - Timex IRONMAN RunTrainer 2.0 W294 Guide De Démarrage Rapide

CONFIGURING SETTINGS FROM YOUR COMPUTER

Make changes to settings from the Device Agent, and then download
those settings to the device.
1. Connect the charging clip to the watch, then plug the USB cable into
the computer. A picture of a connected computer appears on the
watch display.
2. Open the Device Agent on your computer.
3. Select the Run Trainer 2.0 from the Device field.
™
4. Click Settings.
5. Change settings, then click Save.
When the settings transfer is complete, close the Device Agent and unplug
the watch from the computer.
14
Setting up the
Optional Heart Rate Sensor

WEARING THE SENSOR STRAP

1. Adjust the sensor strap so it fits snug to your chest, just below your
sternum.
2. Attach the heart rate sensor to the strap.
3. Wet the heart rate sensor pads on the back of the strap, then put on
the strap.

PAIRING THE HEART RATE SENSOR

Prompt the watch to search for the heart rate sensor and begin receiving
data.
1. Make sure you are at least 30 feet away from other heart rate sensors.
2. Wear the heart rate sensor as described above.
3. From the SETTINGS menu, open SENSORS.
4. Make sure that HEART RATE is set to YES.
5. Select SEARCH, then select HEART RATE.
The watch searches for the sensor. A message
displays when the sensor is found and paired to
the watch.
15