Replacement Parts - ESAB PT-37 Manuel D'instruction

Torches d'oxycoupage plasmarc
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 59
SECTION 6
6.0

Replacement Parts

6.1
general
Always provide the serial number of the unit on which the parts will be used. The serial number is stamped on
the unit nameplate.
6.2
Ordering
To ensure proper operation, it is recommended that only genuine ESAB parts and products be used with this
equipment. The use of non-ESAB parts may void your warranty.
Replacement parts may be ordered from your ESAB Distributor.
Be sure to indicate any special shipping instructions when ordering replacement parts.
Refer to the Communications Guide located on the back page of this manual for a list of customer service phone
numbers.
Bill of material items that have blank part numbers are provided for customer information only.
PT-37 Torch Body Assembly .....................................................................................................................................0558004855
Torch Cable PT-37 4.5' (1.4m) .................................................................................................................................. 0558004890
Torch Cable PT-37 17' (5.2m) ....................................................................................................................................0558004891
Torch Cable PT-37 25' (7.6m) ....................................................................................................................................0558004892
Torch Cable PT-37 50' (15.2m) ..................................................................................................................................0558004893
Hardware items should be available through local sources.
Note
445
REPLACEMENT PARTS

Publicité

Table des Matières
loading

Table des Matières