Cut Data; Pressure Reduction For 4.5' And 17' Torch Lengths; Operation Of Power Source - ESAB PT-37 Manuel D'instruction

SECTION 4
DANgER
4.2

Cut Data

Use the following pages for initial cutting parameters. Variations in material and conditions may require adjust-
ments to be made to obtain desired results.
4.2.1 Pressure Reduction for 4.5' (1.4 m) and 17' (5.2 m) Torch Lengths
With or without Junction Box installed: When using 4.5' (1.4 m) or 17' (5.2 m) torch assemblies, plasma gas set-
tings should be reduced 5 - 10 psi (.35 - .69 bar) for optimum performance.
4.3

Operation of Power Source

For operation of the power source, refer to ESP-101 or Powercut-900/1300/1600 power source instruction man-
ual.
DO NOT USE OxYgEN WITh ThIS TORCh! A hAZARDOUS FIRE MAY
RESULT.
25
OPERATION