Wall Mounting - DeWalt DCB118 Traduction De La Notice D'instructions Originale

A cold battery pack will charge at a slower rate than a warm battery
pack. The battery pack will charge at that slower rate throughout the
entire charging cycle and will not return to maximum charge rate even if
the battery pack warms.
The DCB118 charger is equipped with an internal fan designed to cool
the battery pack. The fan will turn on automatically when the battery
pack needs to be cooled. Never operate the charger if the fan does not
operate properly or if ventilation slots are blocked. Do not permit foreign
objects to enter the interior of the charger.
LITHIUM-ION BATTERY PACKS ONLY
XR Li-Ion tools are designed with an Electronic Protection System that
will protect the battery pack against overloading, overheating or deep
discharge.
The tool will automatically turn off if the Electronic Protection System
engages. If this occurs, place the lithium-ion battery pack on the
charger until it is fully charged.

Wall Mounting

These chargers are designed to be wall mountable or to sit upright on a
table or work surface. If wall mounting, locate the charger within reach
of an electrical outlet, and away from a corner or other obstructions
which may impede air flow. Use the back of the charger as a template
for the location of the mounting screws on the wall. Mount the charger
securely using drywall screws (purchased separately) at least 25.4 mm
(1") long with a screw head diameter of 7–9 mm (0.28–0.35"), screwed
into wood to an optimal depth leaving approximately 5.5 mm (7/32") of
the screw exposed. Align the slots on the back of the charger with the
exposed screws and fully engage them in the slots.
Charger Cleaning Instructions
WARNING: Shock hazard. Disconnect the charger
from the AC outlet before cleaning. Dirt and grease
may be removed from the exterior of the charger using a
cloth or soft non-metallic brush. Do not use water or any
cleaning solutions. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
ENGLI SH
47