Connecting To The Power Source; Portable Power Source; Direct Plug-In Power Source - Welch Allyn LumiView Instructions De Fonctionnement

Connecting to the Power Source

NOTE: The instrument power cord must be plugged into either a
Welch Allyn Portable Power Source No. 75250 or a Welch Allyn
Direct Plug-In Power Source No. 75210.
CAUTION: The lamp housing becomes hot when the
lamp is on for more than 5 minutes and can cause
.
a burn if it contacts the skin. Allow at least 10 min-
utes for cooling between the uses of the illuminator.

Portable Power Source

Plug instrument power cord
l
into the power cord connector
port on top of the power source.
Push in until firmly in place.
l
Gently screw the external
l
connector sleeve clockwise
to secure (optional).
Attach the Portable Power
l
Source by using the belt clip.
The instrument is now ready for use.
l

Direct Plug-In Power Source

Plug Power cord from the
l
Binocular microscope into the
Direct Plug-In Power cord.
Push in until firmly in place.
l
Gently screw the external
l
connector sleeve clock-wise to secure (optional).
Plug direct power source into a nearby receptacle.
l
The instrument is now ready for use.
l
To instrument
1 0