SPORTSTECH CX2 Manuel page 30

Step 6:
1. Guide the Cable (21) of the Handle (20)
through the small opening at the upper end
of the Vertical Frame (15) and out again to-
gether with the Cable (6). Make sure that the
cables are not pinched or fall into the frame.
2. Screw the handle to the stem with 2 washers
(10), 2 spring washers (9) and 2 screws (8).
Step 7:
1. Connect the matching cables of the Console
(1) with the cables that protrude from the
Vertical Frame (15). Pay attention to the plug
direction!
2. Remove the 4 screws (5) on the lower rear
of the Console (1) in order to attach the
console to the Vertical Frame (15). Push the
connected cables back into the frame so
that they do not stick out or get pinched.
3. Attach the tablet holder to the upper back of
the console with the remaining 4 screws (5).
1
3
30
1
2
2